ISO/TS TECHNICAL SPECIFICATION 13399-314 First edition 2018-08 Cutting tool data representation and exchange - Part 314: Creation and exchange of 3D models - Cartridges for indexable inserts Représentationetéchangedesdonnéesrelativesauxoutils coupants Partie314:Création et échanges demodeles 3D-Cartouches pour plaquettesamovibles Reference number IS0/TS13399-314:2018(E) ISO @ IS0 2018 IS0/TS13399-314:2018(E) COPYRIGHTPROTECTEDDOCUMENT IS02018 All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either IsO at the address below or IsO's member body in the country of the requester: ISO copyright office CP 40i : Ch. de Blandonnet 8 CH-1214 Vernier, Geneva Phone: +4122.749 0111 Fax: +41 22 749 09 47 Email:copyright@iso.org Website: www.iso.org Published in Switzerland ii IS02018-Allrights reserved IS0/TS13399-314:2018(E) Contents Page Foreword iv Introduction. V 1 Scope .1 2 Normativereferences .1 3 Terms and definitions. .1 4 Starting elements, coordinate systems,planes 2 2 4.1 General. 4.2 Referencesystem (PCS-Primary coordinate system) 2 4.3 Tool item position. 2 4.3.1 2 General.... 4.3.2 Prismatictool position 3 4.4 Planes. 3 4.5 Cutting reference point (CRP) 4 4.6 Adjustment coordinate system on workpiece side .8 4.6.1 General. 8 4.6.2 Designation of the coordinate system workpiece side 8 5 Design of the model .10 5.1 .10 General 5.2 Necessary properties for insert and pocket seat .10 5.2.1 General. .10 5.2.2 Properties for equilateral,equiangularand equilateral,non-equiangular inserts. .10 5.2.3 Properties for non-equilateral, equiangular and non-equilateral, non- .10 equiangularinserts 5.2.4 Properties forround inserts. .11 5.2.5 Design of the pocket seatfeature .11 .11 6 IS0-cartridge, type A (IS0 5611 series) 6.1 General. .11 6.2 Necessaryproperties .12 6.3 Design of the shank .13 6.4 Design of the basic model .16 6.4.1 General. .16 6.4.2 Models with"P"-clamping system for inserts 17 6.4.3 Models with otherclamping systems for inserts 18 7 Design of details .18 7.1 Basics for modelling 18 7.2 Fixing threads for inserts and radial adjustment 19 7.3 Contact surfaces/drivekeys-Orientation ..19 7.4 Chamfers, roundings. ..19 8 Data exchange model. .19 AnnexA(informative)Mirrorplanesforleft-handedtools .20 AnnexB (informative)Information about nominal dimensions .21 Bibliography .22 @ IS0 2018 - All rights reserved iii