ISO/IEC INTERNATIONAL STANDARD 29341-12-10 Second edition 2015-06-15 Information technology UPnP Device Architecture Part 12-10: RemoteUserInterfaceDeviceControl ProtocolRemoteUserInterface Client Service TechnologiesdeI'information-Architecturededispositif UPnP Partie12-10:Protocole de controle dedispositif d'interfaceutilisateur adistance-Serviceclientd'interfaceutilisateuradistance Referencenumber IS0/IEC 29341-12-10:2015(E) IEC ISO @IS0/IEC2015 IS0/IEC29341-12-10:2015(E) COPYRIGHTPROTECTEDDOCUMENT IS0/IEC2015 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission.Permission can berequested from either IsO at the address below or Iso's member body in the country of the requester. ISO copyright office Case postale 56.CH-1211Geneva 20 Tel. + 41 22 749 0111 Fax + 4122 749 09 47 E-mail copyright@iso.org Web www.iso.org Published in Switzerland i @ IS0/IEC 2015 - All rights reserved ISO/IEC 29341-12-10:201x(E) CONTENTS Foreword Introduction.. vi 1. Scope... 2. NormativeReferences 3. Service Modeling Definitions. 3.1. ServiceType 3.2. State Variables.... 2 3.2.1. CompatibleUIsUpdatelDEvent. 2 3.2.2. CurrentConnections.. 3.2.3. CurrentConnectionsEvent.... 3.2.4. DeviceProfile.. 3.2.5. A_ARG_TYPE_CompatibleUls.. 3.2.6. A_ARG_TYPE_DisplayMessageType 3.2.7. A_ARG_TYPE_InputDataType... 3 3.2.8. A_ARG_TYPE_Int .... 3.2.9. A_ARG_TYPE_String 3.3. Eventing andModeration 4 3.3.1. Relationships Between State Variables 3.4. Actions 3.4.1. Connect 3.4.2. Disconnect... 3.4.3. GetCurrentConnections 3.4.4. GetDeviceProfile. 3.4.5. GetUIListing .9 3.4.6. AddUIListing... 3.4.7. RemoveUIListing. .10 3.4.8. DisplayMessage... 11 3.4.9. Processlnput. 12 3.4.10. Non-Standard Actions Implemented by a UPnP Vendor... 3.4.11. Relationships Between Actions. 3.4.12. Common Error Codes..... 14 Theory of Operation.... 4. .15 4.1. Example Values of State Variables.... .15 4.1.1. A_ARG_TYPE_URI... .15 4.1.2. CurrentConnections.. ..16 4.1.3. A_ARG_TYPE_CompatibleUls.. .16 4.1.4. DeviceProfile.... 17 4.2. RemoteUI Scenariosforthe Basic DCP .18 4.2.1. Connect,DisconnectandGetCurrentConnections 4.2.2. Add, Get and Remove Ul Listings.... .18 4.2.3. Display Message.... .18 4.2.4. Process Input... 18 4.3. RemoteUIScenariosfortheAdvancedDCP .19 4.3.1. Mirror.... .19 .19 4.3.2. Move ... 4.3.3. Reconnect. 19 4.4. Types of Client Devices.... .20 ISO/IEC 2015 All rights reserved ii