ISO INTERNATIONAL STANDARD 19065-2 First edition 2019-03 Plastics Acrylonitrile-styrene- acrylate (ASA), acrylonitrile-(ethylene: propylene-diene)-styrene (AEPDS) and acrylonitrile-(chlorinated polyethylene)-styrene (ACS) moulding and extrusion materials Part 2: Preparation of test specimens and determination of properties Plastiques-Materiauxabased'acrylonitrile-styrene-acrylate (ASA),d'acrylonitrile-(éthylene-propylene-diene)-styrene (AEPDS) et d'acrylonitrile-(polyethylene chlore)-styrene (ACS)pour moulage et extrusion- Partie2:Préparation deséprouvettes etdeterminationdesproprietés Referencenumber IS019065-2:2019(E) @ IS0 2019 IS0 19065-2:2019(E) COPYRIGHTPROTECTEDDOCUMENT IS02019 All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting below or ISo's member body in the country of the requester. ISO copyright office CP 401: Ch. de Blandonnet 8 CH-1214 Vernier, Geneva Phone: +4122 749 0111 Fax: +41 22 749 09 47 Email: copyright@iso.org Website: www.iso.org Published in Switzerland ii @ IS0 2019 - All rights reserved IS0 19065-2:2019(E) Contents Page Foreword .iv Introduction 1 Scope. 1 2 Normative references .1 3 Terms and definitions .3 4 Preparationoftestspecimens .3 4.1 General. 3 4.2 Treatment ofthe material before moulding 3 4.3 Injection moulding 3 4.4 Compression moulding .4 5 Conditioningoftestspecimens .4 6 Determination of properties 4 Annex A (normative) Determination of the bound-acrylonitrile content in the continuous phase.8 @IS0 2019- All rights reserved iii