ISO INTERNATIONAL STANDARD 19044 First edition 2016-11-01 Test methods for fibre-reinforced cementitious composites - Load- displacement curve using notched specimen Methodes d'essai des composites a base de ciment renforces par des fibresCourbe de deplacement de charge utilisant un échantillon entaille Reference number IS0 19044:2016(E) ISO @IS0 2016 IS0 19044:2016(E) COPYRIGHTPROTECTEDDOCUMENT @ IS0 2016, Published in Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission.Permission can be requested from either IsO at the address below orIso's member body in the country of the requester. ISO copyright office Ch. de Blandonnet 8 . CP 401 CH-1214 Vernier, Geneva, Switzerland Tel. +41 22 749 01 11 Fax +41 22 749 09 47 copyright@iso.org www.iso.org ii @IS02016-Allrightsreserved IS0 19044:2016(E) Contents Page .iv Foreword 1 Scope 2 Normative references. 1 3 Terms and definitions 1 4 Symbols 2 5 Test specimen 2 5.1 Geometry 2 5.2 Fabrication of specimen 2 5.3 Loading of specimen 3 6 Test equipment. 3 6.1 Testingmachine 3 6.2 Loading apparatus. 3 6.3 Measuring device for load 4 6.4 Measuring device for CMOD 4 6.5 Measuring devicefor LPD. 5 7 Test procedure .5 8 Calculations 6 9 Test report. 6 1 Annex A (informative)Method of estimatingtension softening curve Bibliography 10 IS0 2016-All rights reserved ii